kollade manualen och där står inget om felmeddelande men där står däremot lite om vad som kan vara fel.
(
http://www.newhorizoncorp.com/PDF/ekomanual.pdf)
Vad händer men din om du börjar elda en liten brasa?
Här hittade jag lite från liknande pannor och jag hade börjat kolla tempsensorn på din
http://www.newhorizoncorp.com/PDF/orlanpelletboilermanualNA08.pdfError: 03 Exhaust temp sensor failure
Device failures
The controller is constantly testing if its internal circuits and temperature sensor are working correctly. After detection of a fault, it
stops the pressure fan, turns on the circulating pump and shows the proper error message on the display. In case of failure please turn
off the controller, plug the circulating pump to the power source, bypassing the controller, ensure appropriate fuel firing in the boiler
and contact the service technician.
When [E 1] error appears on the display, it means fault (short-circuit) in the boiler sensor circuit or temperature below 32°F.
[E 2] is displayed if boiler overheats.
[E 3] error means fault and overheating at the same time. Appearing of [E 1] error on the display without ability to cancel it by
pressing STOP button, in spite of temperature below 190°F, may mean permanent damage of the boiler’s temperature sensor (e.g. if
the boiler overheated above 300°F).
